Set Repeater WRT54GL with DD-WRT

You can set repeater for WRT54GL with Firmware DD-WRT
Step - To - Step.

Assuming your DD-WRT is set to factory defaults, its IP address is 192.168.1.1 (IP defaults), You connect line to port LAN, and set IP for your computer is 192.168.1.2

Step 1. Open a browser on your PC and connect to the DD-WRT rount , its default address is http://192.168.1.1/ The default login is root and password is admin. Of course, you should change these.

Step 2. Click Setup/Basic Setup. You can leave Connection Type at its default, "Automatic Configuration - DHCP. " You can leave the router and host name fields at default if you like, or customize them as we did

The most important setting here is the local IP Address. This must be a different subnet than that which the host AP is on. our host AP is on 192.168.1.1, which was also the default for this DD-WRT router. Thus,we've changed the DD-WRT router to 10.0.0.1. or (192.168.1.x)

You can leave the remaining setting alone -the DHCP enabled, etc. -and click Save Settings at the bottom of the page. Your router will reboot.